4/27/2021 0 Comments Mvci Driver For Honda Hds
Press the ENTER button when you have nished entering the SSID of the access point.IMPORTANT: Means the information demands special attention or that you risk damage to the vehicle or the tool.
Engines produce carbon monoxide, an odorless, poisonous gas that causes slower reaction time and can lead to serious personal injury or loss of life. The MVCI is used to read information from a vehicles electronic control units and sends this information to a PC application. The MVCI communicates to the PC through a USB, Ethernet, or wireless SDIO card. Wireless Connection LED This LED lights solid blue when the wire- less card is con gured. Battery Discharging LED When the MVCI is powered by its inter- nal battery this LED. MVCI Application Installation Insert the CD into your personal computer (PC) CD-ROM tray. Mvci For Honda Hds Install CD WillThe install CD will automatically begin the installation procedure. NOTE: If installation does not automatically begin, go to the Start Menu (XP) or Windows Logo icon (Vista). SPX must be on your PC main drive Plug the external power supply into the MVCI to boot it up. Observe the status and completion of its installation from your PC desktop. Mvci For Honda Hds Driver Will BeUSB Connection - If the USB cable is connected to the PC and MVCI (with power to the MVCI), the USB driver will be automatically recognized. Typically, when a USB connection is chosen, setup to the MVCI is not required. Press the Enter button on your keyboard or click the green check mark located in the lower right corner. NOTE: If the following warning screen appears, press the Enter button on your keyboard or click the green check mark and try again after HDS terminates communication. The MVCI will power on automatically when power is received through the vehicle Diagnostic Link Connector. To turn off the MVCI, disconnect from the vehicle Diagnostic Link Connector, press the ESC button for 5 seconds. Select and Set Up Wireless Security Set Up PC Communication to MVCI. Connect to MVCI. Begin by automatically powering on the MVCI with the AC power supply. Select a Wireless Network Mode to set up: Peer-to-Peer - MVCI and PC communicate directly to each other in a private wireless network. NOTE: Record the SSID for reference when you set up the PC to communicate with the MVCI. An Edit SSID screen appears, it will allow you to manually enter the SSID of your Access Point.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |